| 6. Which of the following is a disadvantage of the waveguide as compared to a transmission line? |
| A. Waveguides can\'t be used at any of the higher frequencies. | | B. Waveguides are more difficult to install. | | C. Waveguides can only be used in low-power applications. | | D. Waveguides leak signal into the air. | |
| Student Answer: A |
| Answer: Incorrect |
| Reference: |
|
| 12. Richard says \"a band-pass filter can be made with a series-tuned LC-circuit.\" Pam says \"a band-pass filter can be made with a parallel-tuned LC-circuit.\" Who is correct? |
| A. Neither Richard or Pam is correct | | B. Pam is correct | | C. Both Richard and Pam are correct | | D. Richard is correct | |
| Student Answer: B |
| Answer: Incorrect |
| Reference: |
|
| 13. For any filter, the more selective the filter is, the closer its shape factor will be to a value of |
| A. 2. | | B. 100. | | C. 0. | | D. 1. | |
| Student Answer: A |
| Answer: Incorrect |
| Reference: |
|
| 14. To remove pulsations from a power-supply output, you could use a |
| A. band-pass filter. | | B. high-pass filter. | | C. low-pass filter. | | D. band-reject filter. | |
| Student Answer: A |
| Answer: Incorrect |
| Reference: |
|
| 15. A line filter would be used to remove |
| A. high-frequency noise spikes from an AC line signal. | | B. line frequencies from an alternator. | | C. pulsating DC voltages from a rectifier. | | D. low frequencies from an AC line signal. | |
| Student Answer: D |
| Answer: Incorrect |
| Reference: |
|
| 19. A filter that always contains at least one tuned LC circuit that\'s either in series with or across the signal line is the |
| A. constant-K filter. | | B. low-pass filter. | | C. high-pass filter. | | D. M-derived filter. | |
| Student Answer: C |
| Answer: Incorrect |
| Reference: |
| 6. Which of the following is a disadvantage of the waveguide as compared to a transmission line? |
| A. Waveguides can\'t be used at any of the higher frequencies. | | B. Waveguides are more difficult to install. | | C. Waveguides can only be used in low-power applications. | | D. Waveguides leak signal into the air. | |
Question 6, Answer:
Ans:D
The waveguide it is a antenna, this means that radiates signal in all directions, leaking signal into the air
Question 12, Answer:
Ans: A
Pam and Richard needs a Circuit RLC
Question 13, Answer:
Ans: C
While factor is lower, the filter it is more closer to an ideal filter
Question 14, Answer:
Ans:D
You need to remove those frequencies who generates the pulsations
Question 15, Answer:
Ans: A
Those Lines attenuate the signals radio with high-frequency
Question 19, Answer:
Ans:B
This filter only have The low Cut-Off Frequencies
Homework Sourse
