PART B IS THE DRAWING ON TOP AND PART C IS THE DRAWING ON TH

X3013. V1f1 10 Vrms T1 Set... Set Set... 0 nv Set. Set. 7. In Multisim, construct the circuit in Figure 2. For this circuit, the transformer turns ratio should be set to 0.2. The load resistor power should be set to 100 watts. 3014 Vi TI 00 Vre 1000 0 Set. Figure 2 Notice how the transformer is connected in this circuit. The primary is connected directly to the an vnltaoe source. as before. However, for the secondary, instead of the lower terminal being

Solution

The transformer in part B is a step up transformer whose primary P(positive) terminal is connected to the source voltage and N(negative) terminal is connected to the ground. Its secondary P terminal is connected to the load of R=100ohm and its N terminal is connected to ground.

The transformer in part C, primary P(positive) terminal is connected to the source voltage and N(negative) terminal is connected to the ground. Its secondary P terminal is connected to the load of R=1000ohm and its N terminal is connected to source.

The size of transformer in part C is relatively more than the transformer in part B as the N terminal in the secondary side of partC transformer is connected to source and also its load is 10 times greater than that of load in part B.