Find data on an induction motor in the range of 10 to 100 HP

Find data on an induction motor in the range of 10 to 100 HP, sufficient to emulate no-load and blocked-rotor tests. Create a report, emulating these tests and produce the equivalent circuit. Describe what you can do with this model in detail. Use Simulink or PSPICE, LTSPICE, or other simulation software to use the model and plot the steady state motor current, speed, and torque at rated conditions.

Solution

We perform PSPICE schematics circuit simulation according to following steps: 1. Design your circuit in schematics. This can be divided into following substeps. 1). First insert all the parts without considering their values (for example, place a resistor without considering the resistance value of it, etc.). 2). Make the necessary rotations for the parts, and move the parts to appropriate locations. 3). Make all the necessary wire connections. 4). Mark the nodes you are interested in with labels. 5). Set the values for all the parts, for example, the resistance values of resistors, the width (W) and length (L) of transistor, etc. 2. Define the SPICE model for NMOS and PMOS transistors. 3. Setup analysis to tell SPICE what simulation you need (transient analysis, DC sweep, etc.) 4. Run the simulation. 5. Observe the simulation results (traces of signals) in OrCAD PSpice A/D Demo