Triangle binding and sinusoidal current Connect three identi

Triangle binding and sinusoidal current.

Connect three identical resistances as shown in picture. Adjust resistances so that the current in phase L2 is about 2,5A. Fill the table.

Draw a vector diagram for each measurement and compare the table with theoretical result for a symmetric network.

The current measured by the ampere meter, that show true effective value Irms=

The voltages are measured using a voltmeter, that show true effective value Urms.

Help.

RMS L2 Instrument Voltmetur 31 Ibundin LI, L2, L3 L2, L3

The backfin of a power mosfet has dimensions 1.0 cm x 1.3cm and a thickness of 1.585mm. It is made out of copper. The purpose of the backfin here is to carry away the heat from the si-based chip attached to the backfin (and here burried in a black plastic case). Thus the backfin is (usually) electrically connected to the mosfet. To mount to a grounded case (Aluminum, quite thick, and at room temperature, 23 oC), an electrically insulating, plastic layer of thickness 0.2873mm and of thermal conductivity 90 W/oC/m is placed between the fin and the aluminum. Assume that the aluminum stays throughout at 23 oC degrees. The mosfet will fail catastrophically (thermal runaway) if its temperature gets above 180oC.
(a) If its RDS in the \"on\" state is 78.88 mOhms, what is the maximum current it can safely conduct in steady state in this mount?
(b) Supose the mosfet was operating just at the breaking point...what would then be the temperature at the shared surface between the copper and the plastic layer?

Triangle binding and sinusoidal current. Connect three identical resistances as shown in picture. Adjust resistances so that the current in phase L2 is about 2,

Triangle binding and sinusoidal current Connect three identi

Solution

Get Help Now

Submit a Take Down Notice