I need help on how to draw this in solidworks step by step o

I need help on how to draw this in solidworks (step by step or at least outlines to be guided please)

IDENTICAL LUGS ON BOTH SIDES Exercise 36 Gripper Rode Center d 28.57 28.52 25 FILLETS & ROUNDS R2 9x82 METRIC CI I REQD

Solution

1) start from the base plate( bottom plane).

2) draw the geometry of the base plane and extrude it for 16 units.

3)On the extruded surface, Draw another sketch but this time by reducing the lugs. Extrude it for 13 units.

4)Select the extruded plane.in the front view. and draw a concentric circle based on the location of the centre point. Draw the other features that adhere to the circle on the left side.
extrude the circle on both sides. 3 units in front and 35 units in back. Extrude the added features for 20 units symmetrical to both directions

5) For the right side features: Select the plane from step 3) and draw the tapered section in front view, and extrude it for 32 units.

6) Select the top face on the right of the tapered place for the extruded surface from step3. draw the remaining feature and extrude it for 19 units.

7) Locate the centre of the holes and draw them accordingly.

8) fillet the required edges, to obtain the rounded edges.