Step by step elaboration please Also please show the necessa

Step by step elaboration please. Also please show the necessary table diagrams using Microcap.

Many thanks.

Use an equal component VCVS structure to design a 2 pole Chebychev LPF circuit with a 3.01 dB (sqrt(2)) ripple channel width and a 2 kHz cutoff. For a Chebychev filter, the cutoff frequency occurs at the frequency at which the gain is 3.01 dB down from that at the top of the ripple channel (use filter tables or adjust peaking for 3.01 dB in MATLAB or Microcap and then get fc - test in Microcap). State the damping factor and the DC gain.

Solution

Damping factor

DF of an active filter circuit determines which response characteristics the filter exhibits. The filter can be a low-pass, high-pass, band-pass or a band-stop type.

The output signal is fed back into the filter circuit with negative feedback determined by the combination of R1 and R2. The negative feedback ultimately determines the type of filter response is produced. The equation below defines the damping factor.

DF=2-R1/R2