Problem Solving Using the problem solving techniques write a

Problem Solving.

Using the problem solving techniques, write a detailed and thorough (complete) set of instructions (write an \'algorithm\') for replacing a corroded car battery. You must also state how to verify the battery is producing acceptable voltage to the automobile. Your solution can be a flow chart or in bullet points. You must state any assumptions you make and write the steps in a logical manner. Be practical more than theoretical. Think like an engineer. How would your algorithm be more \'efficient\' than your classmate\'s instructions? You will be graded on your logic, clarity, neatness, assumptions, limitations, alternatives and practicality as well as creativity.

Solution

1
Open the Hood of a Vehicle|Prop open the hood of your car]. After opening your hood, use the prop rod to keep your hood open (Most newer cars have hoods that hold themselves up.
Be aware that some cars have batteries locate elsewhere, like in the trunk, so you may not need to pop the hood at all.
2
Locate the battery. The battery should be located in an accessible part on either side of the car\'s frame. The battery is a rectangular box with two cables attached to it. Some European cars (some BMW\'s) have the battery under the matting in the trunk, some vehicles can have the battery located under the rear seat, or some are located inside the fender of the wheel well (some Chrysler\'s). The latter is often very difficult to remove.
3
Identify battery terminals. Locate the positive and the negative terminals of the old car battery. The positive terminal will have a plus sign (and is often red) and the negative terminal will have a minus sign (and is often black).