In this problem we will explore how the gears on the 3D prin

In this problem we will explore how the gears on the 3D printed car work. Let\'s assume that you and your group recorded the linear velocity of your 3D Printed Car on the floor to be ~ 0.2 m/s. Given the measurements of the vehicle\'s components shown above, calculate the angular velocity of the motor. If we were to change the design of the 3D car such that the motor shaft gear (diameter = 8mm) were attached directly to the front gear (diameter = 40 mm) as is shown below, what would the resulting velocity of the 3D printed car be?

Solution

The answer of following question is as follows.

The angular velocity of the motor is 65 rad /sec