hi i need help on this questions for engineering graphics GR

hi, i need help on this questions for engineering graphics

GRAPHICSs noDR EXAM 2 TRUEIVALSE QUESTIONSD r of the option that 1. Dimensioning in part files in Inventor follows the same rules as best completes the statement answers A. TRUE or answers the question on the SCANTRON sheet B. FALSE 2. Inserting a hole in Inventor could be done either in a 2.D A. TRUE B. FALSE 3. Cuting plane lines used in Section Views are thin (0.3mm) lines A. TRUE B. FALSE for using section views is to reduce the number of hidden lines in a drawing using 4. An important reason A. TRUE 8. FALSE Lines are added to a section view to indicate hollow areas A. TRUE B. FALSE plane other than one of the six principal views 6. An auxililary view is an orthographic view that is projected onto any pla B. FALSE A. TRUE are not sufficient to describe the object. An auxiliary view is created when two A. TRUE or three views 7. B. FALSE In Inventor, to move from the sketch mode to 3D, click on \"Finish Sketch.\" A. TRUE 8. B.FALSE B. FALSE 9. If a drawing is made in Inventor (from the 3-0 model), going back and changing the part (3-0 model) later A. TRUE mensioning, for a nominal diameter of 55000 inches, an BC

Solution

Answers-

1. TRUE

2. FALSE

3. TRUE

4. TRUE

5. FALSE

6. TRUE

7. TRUE

8. TRUE

9. FALSE