Use the same dataset thread nut runout shank radius head An

Use the same dataset. thread nut runout shank radius head An M14 x 2 steel hex head belt with a nut and no washers is used to clamp together two 30 mm steel plates. Using fastener information found in the text for beth the belt and nut (chapter and appendix), verify the length of the fastener must be greater than 42.8mm, then use 45 mm total length for the start point of all calculations. Using standard belt length sizing, Calculate the recommended grip length for the belt shank, in mm

Solution

Given the diameter of the bolt =14mm

The minimum length of the threaded portion I.e thickness of the nut =0.8*diameter of nut

0.8*14=11.2mm

grip length = thickness of plate +(dia of bolt/2).

=30+(14/2)=37mm